In case you don’t remove the excess paint or stain, you will find a sticky, shiny spots on the deck surface. Wait around half an hour and then brush or roll out any excess stain or finish pooled on the surface of the trex or composite deck. Once the staining is done, you can also apply a coat of composite deck finish following the label direction. In case you want to use oil-based product over the latex coating, you should be careful, otherwise the oil coating may develop cracks that can ruin the appearance of the deck. If you use paint, make sure you use the top quality exterior latex coating. You also need to make sure that all stain in the product is mixed evenly into the stain. Apply a thin, even layer over all of the scratches. Take off the tip of the wax stick, and rub it over the sanded area. Apply wax to the damaged area until it is level. Make sure you stir the stain thoroughly before using. If your scratch or chip is more than 14 in (0.64 cm) deep, consider replacing the board. Once the composite deck is properly cleaned, you need to apply a good quality composite deck stain. During this time, you can cover plants, grass, concrete, trim, or any areas that you don’t want stained. If required, you may need to wait a couple of days for the composite deck to completely dry depending on weather conditions. You can often get some old composite decking. Narrow-width deck boards will not work as well in a fascia application. Multi-Width Decking standard- or wide-width boards can both be used in place of a fascia board for varied looks. The top of the deck board sits flush with the deck surface. You need to make sure that the trex or composite deck surface is clean, dry, and in good condition. Usually, the trex or composite decking is supposed to last forever, so you will not actually need to paint it. This perimeter features a wide-width deck board layered on top of a fascia board. Once done, rinse the deck properly with clean water. Alternatively, you can also use a good quality wood cleaner of your choice. In order to clean the deck, you can use a good quality composite deck cleaner. Mentioned below are some of the most important steps to paint trex or composite decking: Clean the Composite Deck:īefore you start applying paint on the composite deck, you need to sweep excess debris like dirt and leaves off the deck. Therefore, you can surely paint your composite decking when you want to change the color completely or simply like to freshen the look of the deck. In order to make the trex or composite decking look as good as possible, you should put a coat of paint on it.Īlthough manufacturers demand that the color of trex or composite decking is permanent, they will surely fade in time. So, you may want to keep it rather than waste it. You can often get some old composite decking that should be returned for a bad patch, but in reality there are only a couple of problem spots. Usually, the trex or composite decking is supposed to last forever, so you will not actually need to paint it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |